How to Cook Ribs in a Pressure Cooker
To cook ribs in a pressure cooker, season a rack, stand it on a trivet over about 1 cup of liquid, and pressure cook on High for 20 to 30 minutes, then let the steam release naturally. Finish the ribs under a broiler or on a grill for a crisp glaze.
On this page (8 sections)
- How does a pressure cooker tenderize ribs so fast?
- What cut of ribs works best under pressure?
- How do you set up the cooker for ribs?
- How long should you pressure cook ribs?
- Should you use a natural or quick release for ribs?
- How do you keep the ribs from falling apart?
- How do you finish ribs after pressure cooking?
- What side dishes and leftover tips go with pressure cooker ribs?
To cook ribs in a pressure cooker, season a rack, stand it on a trivet over about 1 cup of liquid, and pressure cook on High for 20 to 30 minutes, then let the steam release naturally. Finish the ribs under a broiler or on a grill for a crisp glaze.
The cooker does the long, slow part in a fraction of the time. A rack that takes 2 to 3 hours in an oven can turn tender in 20 to 30 minutes under pressure.
This guide walks through the setup, the timing, the release and the finish so your first batch comes out right.
How does a pressure cooker tenderize ribs so fast?
Trapped steam raises the boiling point of the liquid, so the meat cooks hotter than it would in an open pot. That heat breaks down connective tissue in a pork rack much faster than oven heat does.
A pressure cooker seals steam inside, and the pressure pushes the internal temperature above the normal boiling point. The moist environment also keeps the meat from drying out while the fibers loosen.
Our explainer on how does a pressure cooker work covers the valve and seal mechanics in more detail.
The result is meat that pulls cleanly from the bone without the hours of oven time. Ribs still need some care, though.
Too much pressure time turns the rack mushy and fall-apart before you can glaze it. That's why the timing table below matters more than any single setting.
What cut of ribs works best under pressure?
Pork spare ribs and baby back ribs both work, but they need different times because of their size. Baby backs are smaller and leaner, so they cook faster.
Spare ribs carry more fat and connective tissue and hold up to a longer cook. Beef ribs also work in a pressure cooker, but they need the longest time and a larger pot.
For a 6 quart cooker, keep the rack size in mind before you buy.
Look for a rack that fits your pot without forcing the lid. A whole rack can be curled into a circle, rolled and tied, or cut into sections.
Smaller pieces cook more evenly and stack more easily.
How do you set up the cooker for ribs?
Lay the trivet in the inner pot, pour in the liquid, and stand the seasoned rack on top. Keep the liquid below the trivet so the ribs steam.
- Pat the rack dry and pull off the silver skin from the back.
- Rub both sides with salt, pepper and a spice blend.
- Add about 1 cup of water or broth to the inner pot.
- Set the trivet in place and stand or curl the ribs on it.
- Lock the lid and set the valve to Sealing.
- Cook on High pressure for the time in the table.
If you're new to the appliance, our step-by-step guide on how to use a pressure cooker covers the lid lock and valve positions. A dry rub is enough; a wet sauce can scorch on the bottom if it touches the pot.
How long should you pressure cook ribs?
Cook baby back ribs for 20 to 25 minutes and spare ribs for 25 to 30 minutes on High pressure, then adjust for doneness. Thicker racks and beef ribs sit at the top of those ranges.
| Rib type | Pressure time (High) | Release |
|---|---|---|
| Baby back ribs | 20–25 minutes | Natural, 10–15 minutes |
| Spare ribs | 25–30 minutes | Natural, 10–15 minutes |
| Beef ribs | 35–45 minutes | Natural |
Start at the low end on your first batch. You can always add time, but you can't undo an overcooked rack.
The bone should feel loose when you wiggle it, and the meat should bend without falling apart.
Timing depends on the cooker, too. A 6 quart model reaches pressure quickly and holds it steadily.
The Instant Pot Duo 6 Qt uses its 13 one-touch programs and an Easy-Release steam switch to handle the pressure and release steps.

A 6 quart electric cooker with a one-touch pressure program and a steam release switch that makes the natural release easy to manage.
See it on AmazonIts stainless steel inner pot has a tri-ply bottom, so you can sear the ribs on the Sauté setting first if you want extra color. The same pot handles the steam step without a separate pan.
For more on how it compares, see our pick for the best pressure cooker.
Should you use a natural or quick release for ribs?
Use a natural release for ribs. Let the cooker sit off the heat for 10 to 15 minutes after the timer ends, then turn the valve to Venting to let the last steam out.
A natural release lets the pressure drop slowly and keeps the meat from tearing apart. A quick release drops the pressure fast, which can pull moisture from the rack and make it tougher.
Reserve the quick release for vegetables and other fast-cooking foods.
The Cosori 6 Qt puts its Seal/Vent button away from the steam valve and angles the release back at 30 degrees. That design makes venting safer when you finish the release by hand.

A 6 quart cooker with a ceramic-coated pot and a vent button placed away from the steam stream for a safer release.
See it on AmazonThe ceramic coating is easy to wipe clean after a sticky glaze. Its 12 safety features include a double-layer anti-scalding lid and overheat protection.
If you're still comparing models, read more about how to use a pressure cooker before you buy.
How do you keep the ribs from falling apart?
Keep the rack on the trivet, use enough liquid, and don't overfill the pot. The trivet holds the meat above the water so it steams instead of boiling.
Overfilling with liquid is the most common mistake. Too much water can bubble up and soak the ribs, which washes off the rub.
One cup is plenty for a 6 quart pot.
Don't pack the rack tightly against the pot walls. Steam needs room to move around the meat.
If you stack two racks, curl each one and leave a gap between them.
The Sugaroom rack has 5.2 inch handles and 1 inch legs. The legs keep food above the water, and the handles let you lift the rack out without reaching into the hot pot.

A stainless trivet with long handles and 1 inch legs that keeps ribs above the liquid and lifts out safely after cooking.
See it on AmazonIt folds flat for storage and fits 6 quart and 8 quart electric cookers. The long handles are the useful part when you pull a hot rack out of a full pot.
For more ideas on what to cook next, see how to cook eggs in pressure cooker.
How do you finish ribs after pressure cooking?
Glaze the ribs and broil or grill them for a few minutes to build a crust. The pressure step cooks the meat; the finish adds color, texture and sauce.
Set the oven to broil and line a sheet pan with foil. Brush the rack with barbecue sauce and broil for 3 to 5 minutes per side, watching closely so the sugar in the sauce doesn't burn.
On a grill, cook over medium heat for the same short time.
If you want a crispier bark, pat the surface dry before glazing. A thin coat of sauce works better than a thick one because it sets faster.
Let the ribs rest for 5 to 10 minutes before slicing between the bones.
What side dishes and leftover tips go with pressure cooker ribs?
Serve the ribs with something that soaks up the sauce, like cornbread, slaw or roasted potatoes. The cooker frees up the oven, so you can use it for a side while the ribs finish.
Leftover ribs keep in the fridge for 3 to 4 days. Reheat them covered in a low oven or back in the cooker on the Keep Warm setting.
Add a splash of broth so they don't dry out.
Don't dump the cooking liquid. It's a light broth you can skim and use as a base for beans or a sauce.
Strain it first to remove any loose fat or bone fragments.
For anyone learning how to cook ribs in pressure cooker style, the payoff is time. A weekday dinner that once needed an afternoon now fits between work and bedtime.
Start with baby backs at 20 minutes, taste, and adjust from there. Once the timing is dialed in, the same setup works for chicken and roasts.
Frequently asked questions
Do I need to brown ribs before pressure cooking them?
No. Browning adds flavor and color, but the pressure cooking step tenderizes the meat either way.
Many cooks skip it to save time and finish the ribs under a broiler or on a grill with sauce instead.
Can I stack two racks of ribs in a 6 quart cooker?
Sometimes. A 6 quart pot holds two smaller racks curled around the inner pot, but a large rack must be cut or rolled to fit.
Leave space around the meat so steam can move freely.
How long should ribs rest after pressure cooking?
Let them sit for about 5 to 10 minutes after the lid opens. Resting lets the juices settle and makes the meat easier to handle before glazing and finishing.
Is a pressure cooker faster than an oven for ribs?
Yes. Ribs that take 2 to 3 hours in an oven can turn tender in 20 to 30 minutes under pressure.
The cooker does the tenderizing; the broiler or grill adds the crust.
What liquid works best under the ribs?
Use about 1 cup of water, broth or a mix of broth and vinegar. The liquid creates steam and keeps the pot from drying out, and it should sit below the trivet so the ribs steam rather than boil.
About this guide: Our look at pressure cooker ribs draws on maker specs, materials and what owners report. See how we research.



